Metal Shed, Steel Sheds ,Arrow Shed, ApexRoof, Pent Roof, Garden Storage, Garden Shed, Diy Storage Shed, Storage Shed,Man Sheds, Gable Roof Shed, Car Shed, Livable Shed, Rustic Shed, Porch Shed,Farm Shed, Outside Storage, Steel Garage, Movable Shed
1. Install the floor frame
The floor frame is where all of the wall slot in. So after you have built your foundation, this is your first
job.Make sure that it is square by measuring
diagonally from corner to corner. The measurements should be the same for the
frame to be square. You can then fix the floor frame into your foundation.
2. Put the walls up
Put the walls up and secure them together.This can be fiddly because the panels are
flimsy until they are all held together. It does help to have another person
help you with this.
3. Secure the walls
There will be braces that secure the walls
so they stay together. This includes the door trim which will make the area
around the door much stronger.
4. Put the roof on
Install the gables (which are at the front
and back of the shed), then install the roof beams. The roof beams will give
you a strong foundation to install the roof panels on. They are also where you
will screw your roof panels into.
5. Make the roof watertight
The roof on metal storage sheds have center
and side coverings. These need to be on to keep the water out successfully, and
secure the roof.
6. Install the doors and windows
The last thing you do is install the doors
and any windows.
1. Use a drill. If you have a helper, get them
a drill to. Because there are a lot of screws.
2. You will at a minimum need a drill,
measuring tape, and ladder to complete this instillation.
3. Make sure the surface/foundation is flat
and level. The holes wont line up during assembly if you don’t and it can lead
to water entering the shed
4. If you are finding water in your shed, its
because something has not been put up properly. For a quick fix you can use
silicone to plug the hole.